Parameter Sheet
Wireless transfer | Support Built-in 3G/4G network, WCDMA,CDMA2000,TDD-LTE,FDD-LTE... Support Built-in/External WIFI,Compatible with GPRS,EDGE |
Position | Support Built GPS/BD Module,can make playback analysis of vehicle routing |
Upgrade | Support USB flash disk updating,SD card upgrade , OTA remote upgrade automatically |
File Format | H.264 General video format |
Video Search | Search video by Record Time/Record Type etc |
Playback | Max support 4CH Replay /Stop/Fast Forward/Fast Reverse at same time Support x 2,x4,x8,x16. fast forward or fast backward play |
Safety Management | User/Admin 2 Levels Different Passwords , support screen lock |
Power Management | Adaptive wide power input, support Wide Voltage, Over-load、Over-voltage、Short Circuit、Reverse Protection..Support Time Setting/Delay power off |
Voltage Input | DC:+8V ~ +33V |
Power Consumption | Normal Working <5W Stand-by Status <0.5W |
Temperature | -20℃ to +70℃ |
Net Weight | 0.4kg |
Introduction
Acceleration
SET G-sensor information of alarm threshold and linkage actions.
Before configuration, need to calibrate the current state first, then modify the alarm threshold.
Motion Detection
This menu is to set the image changes and the parameters of the object in the video pictures.
“Threshold “: Main is area alarm percentage, generally set 1 or 2, representing 1% or 2% area change images move,it will trigger motion detection alarm.
“Sensitivity”:0-7 levels, 0 is the highest level, 7 is the lowest level. Generally suggest to set 1, the bigger number you choose ,the lower the sensitivity will be, then it’s not easy to alarm as well.
Specific configuration parameters can depend on actual situation of the scene, such as illumination, detection area range and so on, to achieve the optimal effect.
Voltage Alarm
Low/High Voltage alarm.
Voltage abnormal delay shutdown: it means the voltage is kept below 8V, automatic shutdown time, this can effectively protect the battery, to avoid abnormal conditions caused by the battery voltage shortage, prolong the service life of the battery.
Serial Port Set
External Device parameter setting, can connect LED Advertisement/TTS/Oil/Sensor/POS etc ;
“ Peripheral”:The external device type option,press [OK] For Changing;
“ Baud Rate”:Choose Baud Rate of external device,press [OK] for changing;
“ Data Bit”: Choose the Data bit of external device, press [OK] for changing;
“ Stop Bit”:Choose the Stop bit of external device, press [OK] for changing;
“ Check Bit”:Choose the Check bit of external device, press [OK] for changing;
“Control Bit”: Choose Control bit of external device, press [OK] for changing;