GPS Tracker target installation in E-bike

- Apr 20, 2018-

Electric car locators are divided into wiring and non-wiring, wiring electric car locator installation requires certain steps (described in detail below), non-wiring EV locators do not need to install, directly under the electric car seat or vehicle The place where it can absorb (iron). It is worth noting that it is necessary to pay attention to concealment during installation in order to achieve a good effect of positioning and theft prevention. Next, see how to install the electric vehicle positioner.

Tools to be prepared before installation: Phillips screwdriver, scissors, universal meter, insulating tape, foam tape, nylon tie, waterproof bag



1 Unscrew the screws on the outer plastic baffle of the electric vehicle circuit console. After unscrewing the screws, remove the plastic baffle to see the line console.


2 Find the dedicated external interface in the circuit (or strip the cable yourself and find the normally-connected circuit) and measure the voltage with a multimeter to see if it meets the rated voltage of the device.


3 After connecting the device to the selected power-on line, connect the orange ACC line of the device to the ACC line of the electric vehicle. (The ACC line is opened and the door is powered, closing the circuit with no electricity.)


4 After connecting the ACC cable and turning on the device switch, you can see that the device indicator is on, indicating that the device has started working.


  The location of the electric vehicle locator device directly affects the effect it will reach. If the electric vehicle locator is installed in the wrong position, not only does the alarm effect not be achieved, but also the disassembly of the reinstallation device takes a lot of effort. So the device location is the first one. When positioning the device, the host must be located in the center of the power cord. In addition, the location of the device must be easy to wire, and the wireless host can be installed in the center of all detectors to facilitate signal reception and prevent poor channel conditions from appearing.