Model Name: CA-V2A
Type: GPS Tracker
Frequency band: Quad band
Power input: DC9.5V to 39.9V
Working current: <20mA@DC12V
GPRS: CLASS12, TCP/IP
GPS Antenna: Ceramic
GPS GSM Chip: MTK Solution
Relay: Support 12V/24V
Warranty: one year
APP: IOS and Android system
Protocol: GT06 protocol
CA-V2A uses high quality electronic components. The power supply circuit supports DC9V to 39.9V wide voltage input. And there is one 2A fuse to protect power circuit part.
If the peak current is more than 2A, it also can not damage the PCB components.
Our model supports GT06 protocol, many platforms support this protocol, so you can choose different platform according to your requirements.
1. Getting Location of longitude and latitude
Message command format: #Password#GL#
Replies: contains Google links of longitude and latitude
For example: #6666#GL# will get the current longitude and latitude of device.
2. Getting Address
Message command format: #Password#GA#
Replies: the detailed address
For example: #6666#GA# will get current address of device for example: 6meters , Longhua, Shenzhen, China.
3. Cut off engine
Message command format: #Password#CF#
Replies: Start to cut off engine circuit when speed is less than 20km/h, OK!
It means engine is cut off and you can not drive your vehicle.
4. Start engine
Message command format: #Password#OF#
Replies: Start to open fuel, OK!
For example: #6666#OF# start engine only apply for administrator.
1. Blue LED
Device uses GPRS internet to transfer data
Device can search GSM communication signal
Sleeping mode and no power
GSM module can not work or can not detect SIM Card
2. Green LED
GPS satellite signal is normal
NO GPS satellite signal
Sleeping mode or no power
How to install?
Power cable contains four lines:
Red line and black line is power supply line.
Green line is ignition detection line.
Yellow line is one line can control relay on or off.
Before connects the power cable, please insert 2G SIM Card to the card slot and turn on the battery switch. And make sure the device can work normally.
Question 1: How I can check the position from the platform?
After you install it, you need to add device to our platform and set the IP, Port and APN.
Question 2: On the platform what means the green car?
On the map it displays green car stands for the car is moving.
Question 3: Can I set one place name if there is no it on the map?
Yes, there is one POI function, you can add it yourself.
Question 4: Can I check the mileage from your platform website?
Yes, if you use our platform, you can.