Model Name: CA-V3
Product Type: Vehicle GPS Tracker
GPRS: Class12, TCP/IP
Wide voltage input: DC9V to 40V
Tracking accuracy: less than 5 meters
Device Weight: 0.056kg
Device Size: 9.5cm*4.5cm*1.4cm
Working temperature: -20degrees to 70degrees
Working environment Humidity: 20% to 80% RH
GSM Frequency: 1900/900/1800/850MHz
Working current: 20mA@DC12V
Certificate: FCC CE RoHS
Battery: 3.7V-4.2V Li-ion battery
GPS Chip: UBLOX chip
GSM Chip: MTK chip
CA-V3 GPS Tracker device installation is covert. Please refer installation to an auto electrical contractor.
1. To prevent theft of the device, it should be installed as covertly as possible. Covertly installation is suggested.
2. Avoid placing the device close to higher power electrical devices, such as reversing radar, anti-theft device or other vehicle communication equipment.
3. The device should be fixed into position with cable ties or wide double-side tape.
4. The device has built-in GSM antenna and GPS antenna, during installation, please make sure the receiving side face is up, with no metal object above the device to interfere with GPS reception. The following places are suggested for installation:
Shelter around the front instrument panel (non-metallic material face)
Shelter in the decorated board below the front windshield
In the decorated board below back windshield;
Notice: if the windshield is pasted with metal thermal-protective costing or hearting coating, it may affect the receiving signal. In this case, please change the installation place.
1. GPS Positioning: user can check the real time positioning via computer or mobile phone, we have APP for IOS and Android system.
2. Playback Routes: we can check the vehicle’s routes and speed ACC status within three months.
3. Setting Function Via SMS, user can change IP port and APN via SMS commands. And you can also track device control the engine via SMS commands.
4. ACC Ignition detection: user needs to connect green line to ignition of vehicle, the on the map it can display the ignition status.
5. Voice monitor: monitor the voice around the device.
6. Burglar alarm
7. Vibration alarm: there is shake alarm message or call the administrator’s mobile phone number.
8. Over speed alarm: this alarm is for driving safe.
9. SOS alarm: when user needs help, they can press the SOS button for more than three seconds, then administrator will receive alarm message.
10. Cut off engine: you need to install one relay, then via the relay on or off to control the engineer status.
A. After installing it in the first time, if device can not get connected with platform server, at this time it is “logged off” status in platform.
Please check the installation of device:
1. Check whether the connection of power-line is correct. Please do not connect it with the car control line.
2. Check whether SIM card is installed correctly, please refer to the installation manual.
3. Check whether the power switch is toggled to “ON” , the switch is near USB connector.
4. Check the LEDs’ status. in normal working status, the red Led is in flashing, green LED and blue LED are both in solid bright or flashing.
5. Check whether GPS is located, if not, please drive to the open areas for positioning.
B. If it is “offline” status in platform:
First of all, check the three LEDs’ status. If it is not convenient to check that. Please check SIM card status:
1. Call the SIM card number of the device to check whether you can get through.
2. Check whether the vehicle is in no GSM area, such as basement.
3. Check the GSM/GPS disconnection area, whether it is all disconnected or few of them disconnected, to make sure whether it is the fault of operator’s internet.
4. Check whether your SIM card charge is overdue.
5. Check whether the SIM card supports GPRS.
6. Check the parameter setup, whether the device IMEI number, GPRS sending interval is correct.
1. Red Led: Power status indicator
Working normally (working by backup car battery）
Working normally (working under battery of device) the device will change to work by own battery while backup battery had been cut down. And it will alarm.
Continuously in dark or bright status:
2. Blue Led Light: GSM status indicator)
Working normally, Uploading GPRS data to platform server.
Working normally, Receive GSM signal normally
Continuously in bright status
No GSM signal
Continuously in Dark status
3. Green Led Light : GPS status Indicator
Working normally. GPS located.
Continuously in bright state
Searching GPS signal
Continuously in dark state